Good Quality Plastic Welding - ZX5700 Hot Wedge Welding machine – Heatfounder

Specifications:

 Applications:

It can be applicable for welding PE、PVC、HDPE、EVA、PP and other hot melt material.

  Notice:

1. Unplug the tools before opening it to avoid of being hurt by exposed wires or component inside the machine with power
2. Incorrect use of it can cause fire and explosion hazard because of high temperature, especially near combustible materials and explosive gases.
3. Don’t touch heater tube and nozzle when they are hot. They may cause burns. Don’t point hot air flow in the direction of people or animals.
4. The voltage rating stated on the welder must correspond to line/mains voltage (220V).

The drop cable / wire with protective earthed conductors can only be used.

1. To ensure operator safety and reliable operation of equipment, the power supply must be installed power supply and leakage protection at the construction site.
2. It must be running at the correct use of manipulation of the operator, or they may cause a fire or explosion caused by high temperature.
3. Don’t use welder in the water, or on a muddy construction site, to avoid flooding, rain or moisture.

Please contact us for explosive view of the welding machine.

Welding process:

1. Please lift the pressure handle (14) to separate the upper and down pressure roller (12), then plug the power and open the on power switch.
2. Setting the welding parameters according to the data of welding test.
3. Please wait the actual temperature value reaching the setting value.
4. Put the welder at the welding position and put the two prepared materials (one up and the other one down) into the machine.
5. Press the pressure handle (14) to make the upper and down pressure roller (12) in place. Then open the moving switch (31), the machine would start walking and welding automatically.
6. To observe the relative position of the welding seam and the edge of the welded membrane at any time. It must be promptly corrected if there is deviation.
7. When the welder walks into the end of material, the pressures handle needs to be lifted to separate the upper and down pressure roller in time.
8. After completion of the welding work, press the buttons (24) and (25) on the panel to make the hot air blower in a cold blowing condition in order to cool the nozzle.